Looking for a Australian Legal Forms And Templates? Download it for free!

Department of Housing and Public Works

Form 15—Compliance certificate

for building design or

specification

Version 4 – July 2017

NOTE: This is to be used for the purposes of section 10 of the Building Act 1975 and/or section 46 of the

Building Regulation 2006.

RESTRICTION: A building certifier (class B) can only give a compliance certificate about whether building work

complies with the BCA or a provision of the Queensland Development Code (QDC). A building certifier (Class B)

can not give a certificate regarding QDC boundary clearance and site cover provisions.

1. Property description

Street address

(include no., street, suburb/locality and postcode)

This section need only be

completed if details of street

Postcode

address and property description

are applicable.

Lot and plan details

(attach list if necessary)

E.g. in the case of

(standard/generic) pool design/shell

manufacture and/or patio and

In which local government area is the land situated?

carport systems this section may

not be applicable.

The description must identify all

land the subject of the application.

The lot and plan details (e.g.

SP/RP) are shown on title

documents or a rates notice.

If the plan is not registered by title,

provide previous lot and plan

details

2. Description of

B & D WINDPANEL™ REINFORCED SECTIONAL DOOR WITH VERTICAL BRACES

component/s certified

AND TRACKLOCK – 2.64m HIGH X 6.15m WIDE MAXIMUM FOR USE IN WIND

Clearly describe the extent of work

REGION CLASS C2 THE MAXIMUM ULTIMATE WIND PRESSURE RATING

covered by this certificate, e.g. all

MAGNITUDES FOR WIND REGION CLASS C2 ARE AS STIPULATED IN TABLE 5.2

structural aspects of the steel roof

OF AS/NZS 4505:2012

beams.

3. Basis of certification

Design in accordance with the following SAA codes, drawings, reports,

Detail the basis for giving the

specifications and theory

certificate and the extent to which

tests, specifications, rules,

standards, codes of practice and other

 Test report no.’s TS917 and TS811 (Revision A) from the Cyclone

publications, were relied upon.

Testing Station – School of Engineering and Physical Sciences at

James Cook University

 Principles of Mechanics

 AS/NZS 1170.2:2011 Structural design actions Part 2: Wind actions

 AS 4100:1998 Steel structures

 AS/NZS 1170.0:2002 Structural design actions Part 0: General

principles

 AS/NZS 1170.1 Structural design actions Part 1: Permanent imposed

and other actions

 AS/NZS 4600: 2005 Cold-formed steel structures

 AS1720.1:2010 Timber structures Part 1: Design methods

 AS/NZS 1664.1:1997 Aluminium structures Part 1: Limit state design

 AS/NZS 4505:2012 Garage doors and other large access doors

 AS 3700:2011 Masonry Structures

 AS 3600:2009 Concrete Structures

 Ramset – Specifiers Resource Book

 Buildex Fasteners – Technical specifications

 Engineering drawing numbers 2191/S01J, 2191/S02J, 2191/S03J

and 2191/S04J (attached)

Form 15 - Compliance Certificate For Building Design Or Specification - Queensland Department Of Housing And Public Works

Related Articles

Related forms

Related Categories