Workshop name & address
Touring Caravan Annual Service Checksheet
Please Note: Wheel Nut Torque Should Be Re-Checked After 50 Miles & Also Checked Before Every Trip!
Work must be carried out in accordance with the latest AWS Standard Working Procedures
Customer:
Make/Model
CRIS/Vin
Chassis & Running Gear
P
F
Gas System (Fridge not serviced unless requested)
P
F
Coupling head-check wear/damage & lubricate
Regulator & gas hose-check age, performance & security
Nose weight-check & report (best practice)
Carry out gas leak check
Ball acting stabiliser-check pads
Appliances-check operation of all gas appliances fitted including FFD's
Coupling head gaiter-check for splits
Gas cylinder-check security
Breakaway cable & clip-check condition,routing & integrity
Ensure all gas dispersal vents are clear
Drawbar-check
Corner steadies & spare wheel carrier-check for damage,operation & lubricate
Water System
Jockey wheel-check condition,operation & lubricate
Water pump & pressure switch-check operation
Chassis-check condition,security of assemblies including, chassis to floor security
Taps,micro-switch,valves,pipes & tank (if fitted)-check condition & operation
Wheels & tyres-check for damage or distortion
Water filter & housing-check for leaks & replace filter in necessary
Tyres-assess age & advise replacement if over 7 years
Waste system-check for leaks
Tyres-check condition & wear pattern (incl sidewalls & valves)
Front Axle
Rear Axle
Spare
Water tanks (if fitted)-check security of all water tanks,including underslung
Check & record tyre tread depths
Drain down-winter only (unless advised not to by the customer)
Check & record tyre pressures incl spare
Toilet-check security,operation of flush pump & lubricate seals
Suspension-Visually check condition of rubbers,bushes,dampers & springs
Remove brake drums-clean & check hub bearings & seals
Ventilation
Brake shoes-clean & check condition of linings (including springs & expanders)
Fixed ventilation-check for obstruction & free flow of air
Brake rods,cables & supports-check operation, lubricate & adjust
Check all fixed ventilation is guarded against vermin ingression
Refit brake drums-torque hub nuts to manufacturers settings,adjust brakes & check operation
Roof lights-check for cracks,operation & free of obstructions
Replace road wheels & torque to manufacturers settings (quality control check required)
Handbrake mechanism-check operation,adjust & lubricate
Fire & Safety
Smoke alarm-check operation & replace battery if necessary
Electrical systems
If a fire extinguisher is fitted, check to ensure it is in date
12n,12s/13 pin plugs & cables-check condition & test
If a fire blanket is fitted-check security of its housing
Road lights & reflectors-check condition & operation
Battery (if fitted)-check condition of battery and compartment & check battery charge state
Bodywork
Battery (if fitted)-check & top up level if required & perform high discharge test
Doors & windows-Check operation of all locks,catches,stays & seals
Check battery charge rate from 12s/13 pin plug
Roof-check condition of roof lights & seals & also general condition of roof
Fridge-check operation from 12s/13 pin plug
Grab Handles-check security & sealing
Interior lighting & equipment-check operation & fuse rating
Number plate-check legibility & security
Awning light-check operation
Floor-check for sponginess/delamination
Wiring earths-check for defects on all ELV circuits
Furniture-check condition & operation of all furniture doors,handles & fixings
LV inlet plug & extension lead-check condition & resistance across connection pins
Blinds & fly screens-check tension,operation & material for damage
Earth bonding-carry out resistance check
Damp test-carry out & note readings on a separate damp report sheet
RCD unit-check operation of RCD test button & operation of MCB's
Service information/additional work
230v sockets-carry out plug top polarity test
Charger-check output charge rate at battery connections
Fridge-check operation of fridge on 230v
Check operation of all other 230v appliances,fans & luminaries
Air conditioning (if fitted)-check operation
Check that any additional items fitted are to the correct standard
Signed:
Service Technician:
Owner:
Date:
Wheel nut check 1
Wheel nut check 2
Tick (P) for pass, (F) for fail & enter (N/A) for not applicable
This service report only relates to the condition of the above mentioned caravan at the time of completion of the service. It should not be regarded as evidence of the condition of the items at any other time.
AWS_TC_Annual_Service_Checksheet_090915